Hardware Installation
1.Ensure the power switch is set in the off position. Connect the included power adapter from an available AC power outlet to the Power Adapter Port on the back of the SATDUP13.
2.Using an included SATA Cable, attach the HDD you would like to duplicate to the source port (first port on the left, see below)
3.Using an included SATA Cable, connect up to 3 HDDs you would like to have over written, or erased to the destination ports. (3 ports from right to left , see below
WARNING! Any Data remaining on the destination drives will be over written.
Note: If using less than 3 HDDs, drives should be connected from left to right leaving port(s) closest to the right unoccupied.
4. Press the power switch to the “On” position, the SATDUP13 is now ready to use.
Instruction Manual
3
