Figure 17
Wet glass sleeve
cap. Push it firmly into the
cap until it is completely seated (Figure 18). The filter should stay firmly in the to cap.
12.Ensure that the lower filter
seal is in place | Figure 19 | Figure 20 |
(Figure 19). | Checking lower | Installing the filter in the unit |
13.The lower seal |
|
|
slides over the |
|
|
glass sleeve in the unit. Ensure that the glass sleeve is wet, and guide the filter over the sleeve (Figure 20).
Be sure to guide the outlet tube into the bottom fitting.
14.Tighten the cap and reconnect all fittings. Reconnect power.
15.Run water through the unit for 5 minutes to flush the filter before use.
IMPORTANT! Use only filters supplied by your Sterilight dealer. Approved filters are specifically matched to your unit. Using the wrong filter will negatively effect unit operation, will void the unit warranty, and can adversely affect the safety of water leaving the unit.
REPLACING THE UV LAMP
The Sterilight unit uses a
9