Sterling AF-XXX specifications Program Parameter Descriptions

	Resetting the Unit to Un-Programmed State	25
	JP1 (Program Enable Jumper)	25
	Programming Step by Step Guide	25
	Injection Mode Application Notes	27
4-4	Extrusion Applications	28
	Steps that must be completed before the additive feeder will perform properly:.28
	Extruder Tracking Control	28
	Control Relay Connection	28
	Extruder Tracking Installation and Setup	29
	Field Control Programming	30
	Resetting the Unit to Un-Programmed State	31
	JP1 (Program Enable Jumper)	31
	Programming Step by Step Guide	31
	Extruder Tracking Control Application Notes	32
CHAPTER 5: PROGRAM PARAMETER DESCRIPTIONS		34
5-1	Defining Program Parameters	34
CHAPTER 6: MAINTENANCE		39
6-1	Preventative Maintenance Schedule	39
6-2	Preventative Maintenance	40
	Material Cleanout/Changeover	40
6-3	Corrective Maintenance	41
	Auger Assembly Changeover	41
	Motor Brush Replacement	42
CHAPTER 7: TROUBLESHOOTING		43
7-1	Introduction	43
CHAPTER 8: APPENDIX		46
8-1	Technical Specifications	46
	Annex B Information	46
8-2	Drawings and Diagrams	47
8-3	Spare Parts List	49
8-4	Returned Material Policy	52
	Credit Returns	52
	Warranty Returns	52
8-5	Safety Tag Information	52
	Additive Feeder Safety Tags	52
8-6 Additive Feeder Identification (Serial Number) Tag		53
8-7	Technical Assistance	54
	Parts Department	54
	Service Department	54
	Sales Department	54
	Contract Department	54

Additive Feeders iv