3Iss 1
Quick Start Guide

Assembly

When lifting always keep the back straight, bend the knees and use the lifting handles
provided.
Ensure your rear drive unit is locked in position by checking the rear docking handle
(back light bracket) is fully engaged.
Set the tiller by holding the Tiller Adjustment Lever clockwise while moving the tiller
upwards. Remove the basket from the footboard and place on the bracket located on
the front of the tiller.
Lift battery “B” into the battery tray marked “B Insert First”, then lift battery “A” into
the battery tray marked “A Insert Last”. Ensure battery “A” is located onto the locking
post then lower onto the contacts. Insert the Battery Locking Pin into the locking hole
located at the rear of Battery “A”.
Note:Whenttingthebatteriesputthelargerhandletowardsthefrontofthe
scooter.
Lift the seat onto the seat post and press down to ensure it is fully engaged.

Battery Charging

The battery MUST be charged for 12 hours before rst use. Do not be tempted to use
the scooter unless the battery has been fully charged as failure to do this will result in
battery damage.
Connect the battery charger to the mains supply and the charging socket located on
the left hand side of the tiller fascia panel. Switch on the mains supply and then switch
on the battery charger. RED light = Power On, YELLOW Light = Charging and GREEN
Light = Charge Complete. Charge the scooter overnight after each use to maintain
battery condition (Approx cost 0.20 euros, 15 pence).
If you are in any doubt then please turn to pages 12 and 13 of this manual.

Typical Use

Designed for use on footpaths, for crossing roads and shopping. It should not be
driven through mud, water, snow, sand, loose gravel, long grass or any other unsound
surfaces.