4Iss 1
Quick Start Guide

Control Functions

Transporting

Your scooter is equipped with the following features that can be found on the tiller
fascia panel:
On/ Off Switch, Battery Gauge, Battery Charging Socket, Speed Control “Min to Max”,
Front / Rear Light, Horn and Directional Control Levers.
If you have previously used or owned a scooter before you MUST still read the
Owners Manual carefully to fully understand the controls and safety warnings.
If you are in any doubt of their functions then please turn to pages 7 and 8 of this
manual.
Your scooter may be disassembled quickly and simply for transportation:
1. Lift off the front basket.
2. Remove the seat, leaving the seat stem in position.
3. Remove the battery locking pin and batteries “A” then “B”.
4. Place the basket in the battery wells.
5. Lower the tiller, using the adjustment lever, to its lowest setting locking in the basket.
This will stop the tiller from moving during lifting operations and transportation.
6. De-dock the rear drive unit by lifting the docking handle (rear light) and moving the
front frame forwards. Note: Batteries MUST be removed before the scooter can be
de-docked.
7. Using the lifting handles provided carefully lift the scooter safely and securely into the
luggage compartment of the vehicle.
TIP:
Lift the front wheels in rst and use these to roll the frame along. Use the step at the
boot opening to rest parts if required.
To reassemble the scooter reverse the sequence above.
Important:
When reassembling the scooter, remember to insert the battery locking pin,
because failure to do so may result in the batteries disengaging during use.
Always secure your scooter parts before transportation. Remember to engage
the drive unit by pushing the freewheel lever forwards to stop the scooter from
moving.