Sterling Plumbing 72210106 Technical Information, Installation Notes, Product Diagram, Ensembletm

ENSEMBLETM

Technical Information

Model	Door maximum	Door maximum
	width	height
72210106	38-5/8″(98.1 cm)	70-1/2″(179.1 cm)

Installation Notes

Install this product according to the installation guide.

Size the drain cutout to fit the drain assembly that will be used.

End stud positioning is critical if nailing-in flanges are to be used.

Double studding is recommended for pivot shower door installations.

Studs should be positioned roughly as shown for roofing nail installation.

Attach grab bars at the specified backer board locations only.

13"		16"		13"
(33 cm)				(33 cm)
		(40.6 cm)
	4-1/2"		15-13/16"		10" (25.4 cm)
	(11.4 cm)		(40.2 cm)		4" (10.2 cm)				1-5/8" (4.1 cm)
	D. Drain						26"	35-1/4"
						8"			at Midpoint
	Cutout						(66 cm)	(89.5 cm)
						(20.3 cm)
									34"
									(86.4 cm)
			21"							1-1/4"
										(3.2 cm)
			(53.3 cm)
					Recommended Roofing
	42" (106.7 cm) Min
3-5/16"	42-1/8" (107 cm) Max				Nail Locations (4 total)
(8.4 cm) OD								77"
Drain Hole
								(195.6 cm)
	Back Wall					End Wall				72-1/2"
					3" (7.6 cm)			5-1/2"		(184.2 cm)
					46"			(14 cm)
					(116.8 cm)	14"
						(35.6 cm)
				1" (2.5 cm)					4-1/2"	42"
									(11.4 cm)
				30" (76.2 cm)						(106.7 cm)
				Grab Bar				18" (45.7 cm) Grab Bar
					1"			42" (106.7 cm) Grab Bar
	1"			3"	(2.5 cm)
				(7.6 cm)
	(2.5 cm)
					3-1/2"			22" (55.9 cm)
					(55.9 cm)
Note: Right and left end walls are the same, only mirrored.

Backer board locations

Product Diagram

ENSEMBLETM 42″ (106.7 cm) SHOWER RECEPTOR AND WALL SURROUND WITH BACKER BOARDS Page 2 of 2

1065816-4-A