Sterling Plumbing 882.00253.00 specifications Initial Startup

To change the duration of the password, complete the following steps:

1.On the “System Setup” screen, touch the Operator Password Duration button or the Setup Password Duration button, depending on which password duration you want to change. A keypad pops up.

2.Enter the number of minutes (between 1 and 99) that you want to set as the password duration. Use CLR to erase any mistakes. Use ENT to enter the value. The keypad disappears, and the “System Setup” screen shows the new setting.

3-5 Initial Startup

Once you have finished all the setup described above, you are ready to start the system. To start your system, complete the following steps.

1.At any screen, touch STATION STATUS or PUMP STATUS on the bottom left side of the station status or pump status screen.

2.For each station that you want to use, briefly touch its icon. The icon turns green, indicating that the station is full, or the icon turns yellow, indicating that the station needs material.

3.Touch PUMPS STATUS. The “Pump Status “screen opens (Figure 7)

4.For each pump that you want to use, briefly touch its icon. The icon turns green, indicating that the pump is ready.

5.Touch START SYSTEM in the lower left-hand corner of the screen.

6.The system starts. If any alarm messages appear on the screen, see p. 37.

4 –Pump 38-Station Controllers Chapter 3: Installation 22 of 44