ENGLISH
4.Start position – the electric start motor is activated when the key is turned to the
11.4.8Power take-off (4,5:K)
The power
A lever for engaging and disengaging the power
1.Lever in forward position – power take- off disengaged.
2.Lever in backward position - power
11.4.9Hour meter (2:P)
Indicates the number of working hours. Only works when the engine is running.
11.4.10Clutch release lever
A lever for disengaging the variable transmission. 2WD is equipped with a lever, connected to the rear axle. See (6:R).
The disengagement lever must never be between the outer and inner positions. This overheats and damages the trans- mission.
The levers enable the machine to be moved by hand without the help of the engine. Two positions:
1.Lever in the inner position – transmission engaged for normal operation.
2.Lever in the outer position – transmission disengaged. The machine can be moved by hand.
The machine may not be towed over long distances or at high speeds. The transmission could be dam- aged.
The machine must not be operated with the forward most lever in the outer po- sition. Risk of damage and oil leakage in the front axle.
11.4.11Seat (8:T)
The seat can be folded and adjusted front- rear. The seat can be adjusted as follows:
1.Move the control lever (8:S) upwards.
2.Set the seat to the desired position.
3.Release the control lever (8:S) to lock the seat.
The seat is equipped with a safety switch that is connected to the machine’s safety system. This means that certain dangerous activities are not pos- sible when there is nobody sitting on the seat. Also see 13.4.2.
11.4.12Engine casing (2:U)
In order to access the fuel cock, battery and engine, the machine has an engine casing that can be opened. The engine cas- ing is locked with a rubber strap.
The engine casing is opened as follows:
1.Undo the rubber strap (2:V) at the front edge of the casing.
2.Carefully lift the engine casing back.
Close in the reverse order.
The machine may not be operated un- less the engine casing is closed and locked. Risk of burns and crushing in- juries.
12 AREAS OF USE
The machine may only be used for the following tasks using the genuine STIGA accessories stated.
Work | Accessories, STIGA genuine |
Mowing | Using mowing decks: |
| 95 C, 105 C and with flail mow- |
| er. |
Sweeping | Using brush unit or collector |
| brush unit. The use of a dust |
| guard is recommended with the |
| first option. |
Snow clearance | Using snow blade or snow |
| thrower Snow chains and frame |
| weights are recommended. |
Grass clipping and | Using towed collector 30" or |
leaf collection | 42". Pro Cart. |
Grass and leaf | Using dump cart Standard, Maxi |
transport | or Combi. |
Sand spreading | Using sand spreader. Can also |
| be used for spreading salt. Snow |
| chains and frame weights are |
| recommended. |
Weeding on gravel | Using |
paths |
|
Lawn edge trim- | Using edge trimmer. |
ming |
|
Moss scarification | Using moss scarifier. |
The maximum vertical load on the towing hitch must not exceed 100 N.
The maximum
27
