ENGLISH
2.4.18 Seat (1:T)
The seat can be folded and adjusted front- rear. The seat can be adjusted as follows:
1.Move the control lever (1:S) upwards.
2.Set the seat to the desired position.
3.Release the control lever (1:S) to lock the seat.
The seat is equipped with a safety switch that is connected to the machine’s safety system. This means that certain dangerous activities are not pos- sible when there is nobody sitting on the seat. Also see 4.5.2.
2.4.19 Engine casing (8:U)
In order to access the fuel cock, battery and engine, the machine has an engine casing that can be opened. The engine cas- ing is locked with a rubber strap.
The engine casing is opened as follows:
1.Undo the rubber strap (8:V) at the front edge of the casing.
2.Carefully lift the engine casing back.
Close in the reverse order.
The machine may not be operated un- less the engine casing is closed and locked. Risk of burns and crushing in- juries.
2.4.20Quick-release mounting (31:H)
The quick connections can be separated, which makes it very easy to shift between the different implements.
The quick connections allow the deck to be moved easily between the two posi- tions:
•Normal position with fully tensioned belt.
•4 cm behind the normal position with slackened belt so that the deck gets closer to the base ma- chine.
As the belt idler is released from the belt, the quick connections simplify belt and deck replacement, and also make shifting to the washing position and service positions easier.
Releasing the belt tension:
1.Remove the locking pins (31:G) from both sides.
2.Open the quick connections by depressing their rear sections with your heel. See (31:F).
When the quick connections are opened, the deck arms rest loosely in the shaft sections. The deck must never be set to the service position or washing position without relocking the quick connections after unhooking the deck belt.
3.Carry out the necessary corrective action, e.g.:
•Unhook the belt.
•Replace the deck by unhooking the deck arms. See fig. 33.
Tensioning the belt:
First tension one side and then the other according to the instructions below.
Do not turn the lever using your hands. Risk of crushing injuries.
1.Place your foot on the lever (32:J) and carefully turn a half turn forwards.
2.Install the locking pin (31:G).
3.Carry out the above on the other side.
3 AREAS OF USE
The machine may only be used for the following tasks using the genuine STIGA accessories stated.
Work | Accessories, STIGA genuine |
Mowing | Using mowing decks: 125 Com- |
| bi Pro, 125 Combi Pro El and |
| with flail mower. |
Sweeping | Using brush unit or collector |
| brush unit. The use of a dust |
| guard is recommended with the |
| first option. |
Snow clearance | Using snow blade or snow |
| thrower Snow chains are recom- |
| mended. |
Grass clipping and | Using towed collector 30" or |
leaf collection | 42". |
Grass and leaf | Using dump cart Standard, Maxi |
transport | or Combi. |
Sand spreading | Using sand spreader. Can also |
| be used for spreading salt. Snow |
| chains are recommended. |
Weeding on gravel | Using |
paths |
|
Lawn edge trim- | Using edge trimmer. |
ming |
|
Moss scarification | Using moss scarifier. |
The maximum vertical load on the towing hitch must not exceed 100 N.
The maximum
NOTE! This machine is not intended to be driven on public roads.
63
