English
Electric Handle Heating
Switching on the handle heating system (depending on equipment version)
Starting / Stopping the Engine
Positions of the Master Control lever
STOP
0
lever to Start }and simultaneously release the throttle trigger and throttle trigger lockout.
Simultaneously pressing the throttle trigger lockout and blipping the throttle trigger causes the Master Control lever to jump from the start }position to the operating position F.
Holding the chain saw
There are two ways to hold the chain saw during starting.
219BA048 KN
NSet switch to F– to switch off, return switch to the 0 position
Overheating during continuous use is impossible. The heating system is
219BA035 KN
Stop 0 – engine off – ignition is switched off
Operating position F– engine is running or can start
Start }– this position is for starting the engine
Adjusting the Master Control lever
To adjust the Master Control lever from the operating position Fto Start }, press and hold down the throttle trigger lockout and throttle trigger simultaneously – set Master Control
32 | MS 441 |