Stinger JPEG 2000 user manual DVR Connections, Battery connector Amphenol C16-1 3W+ PE plug PG

Connections

DVR CONNECTIONS

1.RS-232C Port Connection for control of DVR via PC.

2.Alarm/Relay Inputs/Outputs + PTZ Control.

3.WLAN/Laptop Connection: TCP/IP.

4. Camera Connections.

5. Camera LOOP Outputs.

6. 2 x MONITOR Connections.

Battery connector – Amphenol C16-1 3W+ PE plug PG 9

Pin 1	12 VDC or 24VDC (dependant on version ordered)
Pin 2	GND
Pin 3	12 VDC or 24VDC ignition feed (delay off controller)

12VDC camera / TFT connector – Amphenol C16-1 3W + PE PG 9

+12VDC

-12VDC (0V – isolated from Vehicle ground)

NB: BATTERY CONNECTOR

If PIN 1 is connected to a permanent power feed (battery) and PIN 3 to the ignition power feed this enables the “delay off” feature. This means after ignition is switched off the recorder will continue to record for approx 30 minutes. If the “delay off” is not required place an insulated jumper wire from PIN 1 to PIN 3. The DVR will now record only when power is supplied from the main switch (so long as the permanent power feed is behind the main switch).