1.With a clean, dry towel, wipe excess lubricant from the spigot assembly and o-ring. Firmly grasp the spigot assembly with both hands and squeeze the o-ring upward (Fig 16). When a loop is formed, roll the o-ring out of the groove toward the end of the spigot assembly. (See Fig. 17 for a cutaway view of the spigot assembly.)

CAUTION

DO NOT USE ANY TYPE OF SHARP OBJECT TO REMOVEANYO-RINGS.

2.Place all loose parts in a pan or container and take them to the wash sink, filled with warm, soapy water, for cleaning.

3.Wash the product outlet with warm soapy water using the brush provided.

G.For removal and disassembly of the divider plate and agitator assembly, refer to the following steps:

WARNING

PLACE THE ON-OFF-STIR ONLY SWITCH IN THE OFF POSITIONANDDISCONNECTTHEFREEZER FROM ELECTRICAL SUPPLY SOURCE.

1.Remove the drive cap and O-ring from the agitator tube (Fig.18).

Figure 18

Removing Drive Cap and O-Ring

Figure 19

Removing Sealer Ring

3.To remove the divider plate and agitator assembly, the divider plate must be first rotated counterclockwise to unlock and lift out of the product cylinder.

4.Once the divider plate and agitator assembly are lifted off the vertical product cylinder center post and out of the product cylinder, remove the divider plate assembly and anti-lift disc. Remove the plastic agitator bushing from the bottom of the product cylinder center post by lifting up and out of the product cylinder (Fig. 20). - Refer to Figure 23 for an exploded view.

2. Remove the sealer ring by squeezing the looped

Figure 20

section and lifting out of the product cylinder (Fig. 19).

Removing Agitator Assembly and Lower Bushing

13