Figure 5. Disassembling Freezer
E.Remove the spigot body from the front door bypulling the retaining pin out of the spigot handle. Push the spigot body thru the bottom of the front door.
F.Remove the agitator assembly from the freezer. Pull the agitator assembly out of the freezer barrel.
G.Keep the rear of the agitator assembly tipped up once it is clear of the freezer barrel to avoid dropping rear seal.
H.Remove the front agitator support bearing and the two agitator blades.
I.Remove the rear seal assembly.
J.Wipe socket lubricant from the drive end (rear) of the agitator with a cloth or paper towel.
K.Remove all “O” Rings.
WARNING
DO NOT USE ANY TYPE OF SHARP OBJECT TO REMOVE THE “O” RINGS.
NOTE
Figure 6. Front Door and Auger Assembly
SOFT RUBBER | HARD CARBON |
SURFACE | SURFACE |
Figure 7. Rear Seal Assembly
3.4 CLEANING THE FREEZER PARTS
Place all loose parts in a pan or container and take to the wash sink for cleaning. To clean freezer parts refer to the following steps:
A. Place all parts in warm mild detergent water and clean with brushes provided. Rinse all parts with clean hot water.
CAUTION
DO NOT DAMAGE PARTS BY DROPPING OR ROUGH HANDLING.
B.Wash the freezer barrel with warm detergent water and brushes provided.
C.The exterior should be kept clean at all times to perserve the lustre of the stainless steel. A mild alkaline cleaner is recommended. Use a soft cloth or sponge to apply the cleaner.
D.Remove the drip tray insert and drain tray. Clean with a soap solution. Rinse with clean hot water.
3.5 SANITIZE FREEZER AND FREEZER PARTS
A.Use a sanitizer mixed according to manufacturer’s instructions to provide a 100 parts per million strength solution. Mix sanitizer in quantities of no less than 2 gallons (7.5 liters) of 120°F water. Allow the sanitizer to contact the surfaces to be sanitized for 5 minutes. Any sanitizer must be used only in accordance with the manufacturer’s instructions.
B.Place all parts in the sanitizing solution, then remove and let air dry.
3.6 ASSEMBLY OF FREEZER
To assemble the freezer parts, refer to the following steps:
NOTE
6