Storageflex RMC-LC20LP(T), (F) - 2 Accessories continued, Operation, Maintenance, Care Of Blower

Models: RMC-LC10LP - 10 RMC-LC10NG, RMC-LC20NG(F), RMC-LC30NG(F), RMC-LC10NG(T), RMC-LC20NG(T),(F), RMC-LC30NG(T),(F), RMC-LC10LP, RMC-LC20LP(F), RMC-LC30LP(F), RMC-LC10LP(T), RMC-LC20LP(T),(F), RMC-LC30LP(T),(F), RMC-LI10NG, RMC-LI18NG(F), RMC-LI30NG(F), RMC-LI06NG, RMC-LI10NG( (F) RMC-LC20LP(T) RMC-LC10NG (F) - 2

1 16
Download 16 pages 14.13 Kb
Page 15
Image 15
Accessories continued

CFM Home Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice.

WARNING: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

Accessories continued

CAUTION: Damaged power cord can cause a fire or electric shock.

Prior to installing the blower, check for blower for any shipping damage. If blower is damaged, promptly inform dealer where you bought the blower.

INSTALLATION: Plug the blower power cord into a 110-120V properly grounded type outlet (three prong receptacle) protected by a 15 amp time delay or Circuit Saver fuse for circuit breaker.

WARNING: Do not let your fingers touch the prongs of plug when installing or removing the plug from the power outlet.

OPERATION:

Manually Operated: Use the ON/OFF rocker switch to manually switch the blower ON or OFF as desired.

Manually & Thermostatically Controlled: Use the MAN/OFF/AUTO rocker switch to MAN for manual ON or AUTO

for thermostatically controlled operation as desired. Thermostat turns the blower ON when the temperature near the discharge area reaches 105F and turns it OFF when the temperature at the aforementioned location goes down to 86F.

MAINTENANCE:

WARNING: For your safety, turn switch “OFF” and remove plug from power source outlet before cleaning and maintaining blower. If power cord is worn, cut, or damaged in any way, have it replaced immediately.

CARE OF BLOWER

In normal use, blower may accumulate excessive lint or dust, so the blower should be vacuumed or brushed and checked for proper operation at least once each year by a qualified service personnel. Excessive accumulation of lint and dust can cause the blower motor to overheat frequently and burn out.

15

Page 15
Image 15
Storageflex RMC-LC20LP(T), RMC-LC10LP - 10, (F) - 2 Accessories continued, Operation, Maintenance, Care Of Blower