14 | Installation |
|
|
IF INSTALLING A DRIVE INTO THE DS100 4-BAY:
1.If installing 3.5" devices into the DS100, attach the 3.5" adapter brackets (included) to the drives before installing them into the drive bracket (Figure 11). The adapter brackets can be attached to the drive with four (4)
2.Attach the drive activity and drive fault LED cables to the appropriate drive pins (refer to the device manufacturer's documentation for the location of these pins).
3.Install the drive(s) into the drive mounting bracket using four (4)
Drive
(Not Included)
SCSI | ID |
FACTORY |
|
WARNING | NEW |
Drive Mounting Screws
Drive Mounting Bracket Screws
Bracket Tab (Flush with Mounting Assembly)
0544
Figure 14: Installing the Drive into the DS100 4-Bay Drive Mounting Bracket
NOTE: Do not fully tighten the screws . The screws will be tightened after the drive bezel clearance has been checked with the cover.
4.Adjust the drive bracket and drive clearances. In most cases, if the bracket tab (Figure
14)is flush with the DS100 mounting base, no bracket adjustment will be necessary for the drive bezel or filler panel to align with the DS100 cover.
5.If necessary, reinstall the DS100 cover to check for proper drive bezel/cover alignment and make any necessary adjustments to the drive(s)/mounting brackets.
6.Tighten screws.
StorCase Technology, Inc. | DS100 (U320) User's Guide - Rev. A02 |
