Installation | 15 |
|
|
7.If required, tighten the screws that fasten the drive mounting bracket to the chassis.
8.Connect the I/O cable(s) to the drive(s). Make sure the Pin 1 indicator on the cable is aligned properly (refer to the drive manufacturer's documentation for more information).
9.Connect the
10.Connect the ID select cable to the ID select connector on the rear panel of the DS100 (Figures 7 & 8).
NOTE: Use the provided tie wraps included in your installation kit to prevent the power and ID select cables from possible fan contact.
11.Reinstall the DS100 cover and fasten all screws.
12.Connect the power cable to the DS100 and turn ON the power switch. Should there be any unusual sound, turn OFF the DS100 immediately, disconnect the power cable, and remove the cover to locate the source of the problem. Verify that the power and ID select cables are securely fastened with the provided tie wraps and are not contact- ing the fan. Replace the cover.
DS100 (U320) User's Guide - Rev. A02 | StorCase Technology, Inc. |
