Stovax Gazco Ceremica Log Effect Stove Range Replacing Parts, Servicing Instructions, General

SERVICING INSTRUCTIONS

REPLACING PARTS

1.GENERAL

1.1All principal components can be replaced without removing the stove from its installation, although it will be necessary to remove the door and ceramic outer casing in order to access most components. In order to remove the casing, use the following procedure:

1.2Remove the door retaining nuts using the tool provided and place the door to one side.

1.3Carefully remove the top blanking plate and grille and place to one side, gently remove the top ceramic panel, see Diagram 1. If the unit has been connected to a top exit flue, it will be necessary to lift and support the grille and top ceramic panel whilst removing the outer ceramic components.

1

AR0492

1.4Gently lift the front ceramic panel, and pull away from the sub-frame to clear the retaining bolts, see Diagram 2.

2

1.5Carefully remove the two side panels by lifting, and gently pulling clear of the retaining bolts, see Diagram 3. It may not be necessary to remove both of the side panels. This should allow full access to all major components.

3

AR0488

2.MAIN BURNER

2.1Turn the gas supply off at the isolation device, remove the door and place to one side, carefully remove the ceramic fuel bed components.

2.2Remove the three securing screws, two at the rear and one at the front left-hand side. See diagram 4. Raise the left- hand side of the burner to clear the bracket, draw the left- hand side forward. The burner venturi is engaged over the injector. When removing the burner be sure to clear the injector, this will release the right-hand side of the burner. Take care when removing the burner so as not to damage the pilot burner.

4

AR0490

AR1605

2.3To replace the burner, engage the venturi over the injector ensuring the burner sits on top of the fixing bracket. Push the burner to the right and whilst holding, insert the three fixing screws.

17