SERVICING INSTRUCTIONS
REPLACING PARTS
7.3Reassemble the interrupter block and leads. Secure the thermocouple connection in the rear of the gas control (Do not overtighten). Turn the gas supply on and check the entire pipework and valve joints for any leaks.
8.MAIN INJECTOR
8.1Turn the gas supply off at the isolation device. Refer to Section 2, Replacing Parts to remove the main burner.
8.2Undo the compression nut from the feed pipe at the gas control under the appliance.
8.3Working from inside the firebox, remove the lock nut from the injector, see diagram 15 and withdraw the injector complete with the feed pipe from under the appliance. See diagram 15.
15
AR0618
8.4Holding the injector with a spanner, undo the feed pipe.
NOTE: THE ORIENTATION OF THE INJECTOR.
8.5Reassemble in reverse order. Turn on the gas supply and check for any leaks.
9.GAZCO FLUE SURE SYSTEM
9.1Remove the front door by undoing the four dome nuts and remove the cast iron door. NOTE: THE CAST IRON DOOR IS HEAVY. TAKE EXTREME CARE WHEN HANDLING.
Carefully remove the coal retainer and ceramic components and place to one side. Remove the burner casting by removing the three screws located on the sides of the burner skin.
16
9.2Remove the screw on the back panel and remove the panel. Refer to Diagram 17.
17
AR1606
9.3Undo the two screws at the back of the firebox and carefully withdraw the bracket.
18
AR1607
9.4Disconnect the two slender wires. Undo the two taptite screws and remove the sensor and the two plastic spacers. See diagram 19.
19
AR1446
AR1605
20
