INSTALLATION INSTRUCTIONS
INSTALLATION
3.2.6To determine the length of the terminal flue section measure from the outside of the wall to the stop on the 90° elbow. Horizontal flue sections may fitted between the elbow and the terminal section. See diagram 7.
7
AR0629
3.2.7Once the length of the terminal has been obtained, mark the flue all the way round, insert the cardboard fitment as shown in diagram 8. This will support the inner flue. When cutting take care not to damage the edges of the flue. File any sharp edges from the cut end of the flue.
8
AR0630a
REMOVE ANY CARDBOARD FITMENT REMAINING.
3.2.8Remove the stove and flue assembly from the hearth and drill the four fixing holes for the wall plate, insert the rawlplugs supplied. Assemble the horizontal flue onto the elbow and reposition the stove ensuring the flue slides smoothly through the wall. alternatively, place the flue terminal in the wall, place the stove on the hearth and connect the flue to the elbow. Reposition the stove.
3.2.9Fix the wall plate to the wall using the four black screws provided. Drill through the fixing tab of the wall plate using a 3.5mm drill and secure with the screw provided. Make good and weatherproof around the outside of the flue.
3.3 TOP EXIT - VERTICAL FLUE
3.3.1If a vertical only flue system has been purchased refer to Site Requirements, Diagram 5.
The following areas need careful consideration:-
a)Terminal positions
b)Flue supports
c)Weatherproofing
d)Fire precautions
For all of the above, local and national codes of practice must be adhered to.
TABLE A - TOP EXIT – VERTICAL ONLY,
INCLUDING OFFSET
|
|
|
|
| Vertical Height | Restrictor Size | |
| From Floor |
|
|
| 3,000mm to 4,990mm | 52mm Ø |
|
| 5,000mm to 10,000mm | 47mm Ø |
|
| Flue temp | 400°C | |
|
|
|
|
4. HANDLING & DISPOSAL OF FIRE CERAMICS
The fuel effect and side panels in this appliance are made from Refractory Ceramic Fibre (RCF), a material which is commonly used for this application.
Protective clothing is not required when handling these articles, but we recommend you follow normal hygiene rules of not smoking, eating or drinking in the work area and always wash your hands before eating or drinking.
To ensure that the release of RCF fibres are kept to a minimum, during installation and servicing a HEPA filtered vacuum is recommended to remove any dust accumulated in and around the appliance before and after working on it. When servicing the appliance it is recommended that the replaced items are not broken up, but are sealed within heavy duty polythene bags and labelled as RCF waste.
RCF waste is classed as stable,
Excessive exposure to these materials may cause temporary irritation to eyes, skin and respiratory tract; wash hands thoroughly after handling the material.
16
