INSTALLATION INSTRUCTIONS
SITE REQUIREMENTS
2. VENTILATION
The appliance requires no additional ventilation.
| 3. INSTALLATION OF THE GAS SUPPLY |
3.1 | Before installation, ensure that the local distribution |
| conditions (identification of the type of gas and pressure) |
| and the adjustment of the appliance are compatible. |
3.2 | Ensure that the gas supply is capable of delivering the |
| required amounts of gas, and is in accordance with the rules |
| in force. |
3.3 | Soft copper tubing and soft soldered joints can be used but |
| must not be closer that 50mm (2") to the underside of the |
| firebox. |
3.4 | A means of isolating the gas supply to the appliance must be |
7
PR0846-
AR0522
provided independent of any appliance control. |
3.5 All supply gas pipes must be purged of any debris that may |
have entered, prior to connection to the appliance. |
4. APPLIANCE LOCATION |
4.1This fire must stand on a
*
AR0531
6
AR0604
MINIMUM CLEARANCE
4.2The fire is not suitable for installation agianst a combustible wall. All combustible materials must be removed from behind the fire.
4.3Ensure you comply with all minimum clearance measurements, whether or not to combustible materials.
The above dimensions provide adequate clearance at the side and rear of the fire so that the controls can be reached.
5.TIMBER FRAMED BUILDINGS
5.1It will be necessary to provide additional clearance when the fire passes through a wall containing any combustible materials as so to prevent a fire hazard.
5.2The hole through which the flue will pass, must have a steel sleeve which is positioned so that an air gap of at least 25mm is maintained between the outer surface of the flue, and any part of the sleeve.
5.3For further guidance on the installation of gas appliances in timber framed buildings, contact your local buildings control authority.
NOTE: ATTENTION MUST BE GIVEN TO ALLOWING ADEQUATE CLEARANCE AT THE SIDES AND REAR OF THE STOVE, TO PROVIDE ACCESS FOR SERVICING.
12