Control Panel Operation
Jets | Touch the “Jets” button once to activate the low speed of the pump and again | ||||||
|
|
|
|
|
|
| for the high speed. Press the “Jets button again to turn off the pump. If left run- |
|
|
|
|
|
|
| ning, the low speed of the pump will automatically turn off after 4 hours, and |
|
|
|
|
|
|
| the high speed will automatically turn off after 15 minutes. It may also activate |
|
|
|
|
|
|
| for at least 2 minutes every 30 minutes to detect the spa temperature and then |
|
|
|
|
|
|
| to heat to the set temperature if needed, depending upon mode. When the low |
|
|
|
|
|
|
| speed turns on automatically, it cannot be deactivated from the panel; however, |
|
|
|
|
|
|
| the high speed may be started. |
|
|
|
|
|
|
|
|
Light | There are several color options in our spas and by pressing the light button in | ||||||
|
|
|
|
|
|
| quick succession the customer can cycle through the different lighting options. |
|
|
|
|
|
|
|
|
Temp | The | ||||||
|
|
|
|
|
|
| is constantly displayed on the LCD. |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| To display the set temperature, press the “Temp”button once. |
|
|
|
|
|
|
| To change the set temperature, press the temp up or temp down button before |
|
|
|
|
|
|
| the LCD stops flashing. Each press of the “Temp” button will continue to either |
|
|
|
|
|
|
| raise or lower the set temperature. After 3 seconds, the LCD will stop flashing |
|
|
|
|
|
|
| and display the current temperature. |
BEFORE START UP! IMPORTANT UNION ADJUSTMENTS
There are FOUR unions that may require hand tightening prior to operation of your spa. When filling the spa with water, keep observing these fittings for any slight water drips. If a drip is observed, just hand tighten until dripping ceases.
5