STUDER INNOTEC | AJ |
English description
Introduction
The sine wave inverters of the AJ series have been designed to meet industrial and domestic needs. They meet the highest requirements of comfort, safety and reliability.
Any device designed for the public electrical network of 230 V 50 Hz can be connected to them (up to the nominal power of the inverter).
The AJ series is the perfect source of voltage in any place where the public network is not available.
This document is an essential part of the inverter and must always be carried with it and be at the disposition of anyone working on the installation.
Should you have any doubt or question, do not hesitate to contact your specialist salesperson who will give you the best advice.
Warning
A deficient assembly could result in damage to the device, cause function failures or potential damage to the users.
The working device generates a high voltage which might be lethal in case of contact. So, any manipulation of the inverter must be carried out with utmost care.
THE OWNER MUST NOT MANIPULATE ANY PIECE INSIDE THE INVERTER.
Opening the inverter or using it incorrectly will result in the immediate loss of the warranty.
No current or tension generating device (public grid, generator,... ) may be connected to the outlet of the inverter
because this could result in its destruction.
The inverter AJ is to be used only with a lead battery. As for the use of batteries, follow the manufacturer’s instructions.
Installation
The AJ sine wave inverter is an electronic device, for which some caution must be taken when installing it: Place where the inverter is to be installed:
Out of reach of unauthorised persons, specially children.
In a dry place (max. 95% humidity), and in any case with no condensation.
Not directly on top of the batteries. Ventilation must be free, and a space of 10 cm. on each side is needed for good evacuation of the internal heat.
Fitting the inverter
The inverter is fitted by screws (max. 4mm for AJ
AJ V2.1 | 3/24 |
