STUDER INNOTEC
Introduction
The SI sinewave inverters have been designed to meet industrial and domestic needs. They satisfy the highest demands of comfort, safety and reliability.
Any device designed for the public electrical network of 230V / 50 Hz can be connected to them.
The SI inverters are the perfect solution as sources of tension in any place where the public network is not available.
Read the connection instructions thoroughly and give them to the technician who is to install the inverter so as to prevent any malfunction. Thus you will have a modern and reliable installation which meets requirements.
Should you have any doubt or question, do not hesitate to contact your specialist salesperson who will give you the best advice.
Note
A deficient assembly could damage the device, cause function failures or potential damage to the users.
The working device generates a high tension which might be fatal in case of contact. So, any manipulation of the inverter must be carried out with utmost care. The following points must be strictly observed :
The installation of the "SI" can only be performed by a qualified technician.
In case of malfunction, only a technician specially designated and trained by STUDER INNOTEC is allowed to repair the device.
Warning :
Opening the inverters or using them incorrectly will result in the immediate loss of the warranty.
No current or tension generating devices (public network, generator, ...) may be connected to the output of the inverter because this could result in its destruction.
SI
As for the usage of batteries, follow the manufacturer’s instructions.
Important :
After disconnecting the battery, the output
tension (230V) may still remain for 30
seconds.
The ventilation of the device should never be obstructed. Should the device be installed in an enclosed structure, make sure that ventilation is possible and adequate.
The installation and assembly of the device must follow the rules stipulated.
This document is an essential part of the inverter and must always be carried with it and be at the disposition of anyone working on the installation.
Applications and Performance
As well as its modern design and its technical characteristics, the SI inverter is also easy and economical to use in almost all applications.
All devices working within the public electrical network (230V - 50Hz) may be used with the inverter (up to its nominal power).
The inverter generates a perfectly sinusoid output tension, precisely adjusted by a high technology regulation system.
Thus, the output tension is totally independent of the charge and the fluctuation of tension in the battery.
All inverters in the SI series are protected against overloading and short circuits.
Due to obvious safety reasons, the inverter is not automatically reactivated after a failure (overload, short circuit,…).
Product presentation
The inverters of the SI series are presented fully equipped, with battery cables, 230V cable and the user's handbook.
User manual | SI V3.0 E | 3 |
