Studer Innotec XTH 3000-12 12 Control and display parts for the Xtender (fig. 4b) , 13 Type plate elements (fig. 3b)

Steca Xtender

Installation and Operating Instructions 723.932 Xtender V0.511 Seite 34

12 Control and display parts for the Xtender (fig. 4b)

See chapter 7.1 - p. 26.

Pos. Deno

minat

ion

Description Comments

41 ON/OF

F ON/OFF button The ON/OFF button allows the startup or complete

stoppage of the system such as it has been programmed.

When there are several units in the same system, each unit

must be started up or stopped individually using this button.

42 OFF Light indicator for

stoppage of the

unit

When the light indicator flashes it indicates the cause of the

stoppage of the unit, its imminent stoppage or the limitation

of its rated power output according to chapter 7.1 - p. 26.

43 ON Light indicator

showing that the

equipment is in

operation

This indicator is glowing continuously when the device is

working. It flashes when the equipment is at a temporary

stop. Note: The equipment will restart automatically when

the conditions that led to the temporary stoppage have gone

away.

44 Charg

e Light indicator

showing that the

battery is being

charged

This indicator is glowing continuously when the charger is in

operation and has not yet reached the absorption phase.

It flashes twice during the absorption phase and once during

the maintenance phase.

If smart boost mode has been activated it is possible that

this indicator will go out temporarily when source backup is

required by users. (See chapter 6.2.7 - p. 21)

45 AC in Light indicator

showing the

presence of

correct and

synchronised

input voltage

This indicator is glowing continuously when an alternative

voltage with correct values is present at the AC IN input (13)

of the device and the current limit {1107) set by the user has

not been reached. It flashes when this limit is reached (see

chapter 6.2.6 – p. 21).

46 AC out Light indicator

showing the

presence of a

voltage at the

output

This indicator is glowing continuously when an alternative

voltage of 230V is present at the device output. It flashes

when the device is in “load search” mode due to the

absence of users. (See chapter 6.2.2 – p. 18)

13 Type plate elements (fig. 3b)