Sub-Zero 315 manual Place ice maker in front of installed location. Adjust

INSTALLATION

Plumbing

Model 315P – Pump Model

1) Place ice maker in front of installed location. Adjust

PRE-INSTALLATION SPECIFICATIONS

MODEL 315P (PUMP)

	leg levelers to approximately correct position.
2)	Remove control knob, control panel and control access
	panel.
3)	Route water inlet line from wall through ice maker to
	the front.
4)	Locate coil of 3/8" ID plastic drain tubing secured to
	the back of the cabinet.
5)	Route plastic drain tube from back of cabinet to drain
	connection point.

IMPORTANT NOTE: Often an air gap is required by local codes between the ice maker drain tube and the drain receptacle.

SHUT-OFF

VALVE

WATER

FILTER

AIR GAP

DEVICE

1/8" (3)

WATER

INLET TUBE

DRAIN

TUBE

24"

(609)

151/4"

(387) MIN.

TOP VIEW

6)If electrical outlet for ice maker is behind the cabinet, plug in the ice maker now.

7)Push ice maker into installed position.

8)Cut off water inlet line at required length.

9)Flush water line. Place flare nut on inlet water line and flare the end of the copper tube.

10)Attach flare nut to the male flare on the inlet water valve.

11)Turn on the water supply, and make sure that the ice maker is plugged in and the power is on.

12)Pour a couple of quarts of water into the storage bin, the drain pump should start and pump water out. Check for leaks.

13)Replace control knob, control panel and control access panel.

14)Level the cabinet as needed.

IMPORTANT NOTE: All plumbing must meet local codes.

AIR GAP

DEVICE

341/2"

(876) NOMINAL

DRAIN	33 3/4"
TUBE	(857) MIN.

WATER

SHUT-OFFINLET TUBE

VALVE

WATER	151/4"
FILTER	(387) MIN.

FRONT VIEW

Drain Pump Kit

This ice maker can be ordered with (Model 315P) or with- out (Model 315) a pump. Models without a drain pump drain their water by gravity. However, gravity drain models may be converted to pump models through the installation of a drain pump kit and drain pump.

Two parts are required for this conversion:

Drain pump kit part number . . . . . . . . . . . . . . . A36892020

Drain pump part number . . . . . . . . . . . . . . . . . . 12250321

Specific step-by-step instructions are included with the kit.

7