INSTALLATION
Panel Considerations
Refer to instructions for installation under "Panel Installations". You should be sure of panel sizes and place- ment before proceeding with installation. If you have questions, contact the selling
IMPORTANT NOTE: Do not install hinge covers until the door swing direction and door stop angle have been final- ized.
Side Panels
With Model 315 you must securely fasten the side panels to adjacent cabinets and floor.
Panels should be fastened to the floor and walls using "L" brackets (hardware not provided). To help you move the unit into place, route out an area in the floor so the ‘L’ bracket will sit flush with the floor level. Brackets and screws are provided for mounting the unit to adjoining cabinets and side panels.
Reversing Door Swing
The hinged side of the door may be reversed to the other side if desired.
The Model 315 was shipped with the door hinged at the right. The door and hinges are designed for placing the hinges on either the right or the left side of the cabinet. Moving the hinges to the left in the
IMPORTANT NOTE: There is a part, packed with the ice maker, that is required for this procedure.
1)Remove the hinge cover.
2)Remove the door by removing the (4) screws that secure the door to the door hinges.
3)Remove the door hinges by removing the (4) screws that secure them to the cabinet.
4)Remove the (4) screws from the opposite hinge side (or
5)Install the hinges using the
6)Install the door using the
7)Remove the (2) screws which secure the upper door panel mount bracket.
8)Install the upper door panel mount bracket using the
9)Install the
10)Check the operation of the door by opening and clos- ing it.
9
