Sub-Zero Sub-Zero manual E R L a Y D O O R P a N E L S, N E L Q U I R E M E N T S

O V E R L A Y D O O R P A N E L S

If you and your client have ordered an overlay design model, you will be adding panels to give the unit the custom Sub-Zero look. The overlay panel design option is available on all Built-In units except Models ICB648PRO and ICB648PROG.

For exact door panel dimensions for Built-In overlay models, refer to the Overlay Panel Speci- fications on pages 22–23.

The overlay design allows decorative panels to cover the door trim for a more seamless appearance that blends with the design of the room. To achieve this look, the most common way is to work with three panels—the decorative overlay panel, a 3 mm spacer panel and a 6 mm backer panel. Depending on your cabinet manu- facturer, this could be one panel routed for different dimensions or, more likely, three differ- ent panels.

Regardless of the physical construction of the panels (routing or three-panel assembly), you will need to follow the Overlay Panel Specifications on the following pages for exact sizing and panel placement to ensure a proper fit.

Illustration 3 is a cross section view of the three- panel assembly showing placement of the door, drawer or grille trim. Illustration 4 shows a rear view of the three-panel assembly and critical dimensions, standard for all models.

IMPORTANT NOTE: Keep in mind that the Sub-Zero door panels have the potential for hitting adjacent cabinets and/or countertops when they are opened. You need to be aware of your surrounding cabinetry and space limitations when using the overlay models. Refer to the full- scale illustrations at the end of this section.

If you are using an overlay door panel with Model I611, I611G, I650 or I650G, it is necessary to rout a space for the unit‘s lower hinge plate so it does not strike the door panel. Refer to illustration 5.

For Models I611, I611G, I650 and I650G, you will minimize the reveal between the bottom of the overlay door panel and the top of the overlay drawer panel. Refer to illustration 6.

IMPORTANT NOTE: If you choose not to rout a space for the lower hinge plate, you can reduce the total height of the overlay panel (decorative panel only) by 13 mm.

Do not exceed the overlay decorative panel dimensions for Models I611, I611G, I650 or I650G listed on page 22. If you try to make the reveal tighter between the door and drawer panels, the panels may hit when opening and closing, causing possible damage to the panels and the Sub-Zero unit.

P A N E L

R E Q U I R E M E N T S

The overlay door panel assembly must be a minimum of16 mm thick and cannot exceed 23 kg.

Spacer Panel
3	Overlay Panel
mm
	6 mm Backer Panel
	8 mm min
	4 mm	Door/Drawer/
	2 mm	Grille Trim

Overlay Panel	Spacer Panel
~19	Backer
mm	Panel
3 mm	6 mm

	Overlay Panel
	6 mm Backer Panel
	Spacer Panel
	76 mm
13	Bottom Edge –
mm	Hinge Side
10 mm	(rear view)

Overlay Panel	Spacer Panel
	Backer
	Panel
	8
	mm
21
mm	13 mm

Illus. 3 Illus. 4 Illus. 5 Illus. 6

19