Sub-Zero Sub-Zero manual A I N P U M P M O D E L 3 1 5 I P, O R P a N E L M O D E L 3 1 5 I P

I N S T A L L A T I O N

Refer to the installation instruc- tions shipped with each Sub-Zero product for detailed specifications.

D R A I N P U M P – M O D E L 3 1 5 I P

This ice maker comes with a built-in drain pump. The drain and inlet water tubes must be plumbed before connecting to the ice maker. An air gap will likely be required between the ice maker drain tube and the drain/waste receptacle. A stand pipe with a trap below it would be acceptable for the drain/waste receptacle. Refer to the illustrations below.

IMPORTANT NOTE: Poor drainage will cause a high rate of ice melting in the bin.

D O O R P A N E L – M O D E L 3 1 5 I P

It is important to understand the differences in mounting any wood panel to the Model 315IP. Refer to the installation instructions packaged with the unit to understand how the panel is installed. It does not require a 6 mm backer. Door panel dimensions are 381 mm wide by

772 mm high and must be a minimum of 16 mm thick. The maximum door panel weight is 7 kg. No handle recess is required.

I N S T A L L A T I O N S P E C I F I C A T I O N S

Model 315IP – Drain Pump

SHUT-OFF	3 mm
VALVE
	WATER
	INLET TUBE
WATER	DRAIN
FILTER	TUBE
AIR GAP
DEVICE

AIR GAP

DEVICE

				876 mm
609 mm				NOMINAL
			DRAIN	857 mm
			TUBE	MIN.
			WATER
	SHUT-OFF	INLET TUBE
	VALVE

68

387 mm MIN.
TOP VIEW	WATER	387 mm MIN.
	FILTER
		FRONT VIEW