NOTE: In case the rotor cannot pull out, please do the following ways.
1. Prepare the tool in the dimensions of the following for pulling out the rotor.
L, a ,
T!
-i‘T
-1
-I
MODEL 1 L 11) A’B jC1D ! Pitch
RGX305 / 250mm : 33mm I @lOmm / @mm , 20mm i 12mm 1.5mm
RGX305D : 9.8” 1.3” ; $0.39” G50.31” ( 0.79” i 0.47” : 0.06”
RGX405 1 235mm ’ 33mm f$lOmm / @mm , 20mm / 12mm 1.5mm
RGX405D , 9.3” : 1.3” j 40.39” ’ (bO.31” ; 0.79” 0.47” ! 0.06”
RGX505 ! 266mm 33mm
RGX505D i 10.5” 1.3”
1 @lOmm !
#8mm 20mm i 12mm 1.5mm
i qlo.39” ! #0.31” 0.79” ’ 0.47” I 0.06”
Table 1 O- 1
Parts numbers of the rotor puller are as follows:
I
Parts No. ’ Parts Name 1 Description I
I 367 543308 i SHAFT i RGX305, RGX305
I I,
1 RGX405, RGX405D
,I
RGX505, RGX505D
367 543308 / BOLT RGX305, RGX305D, RGX405, RGX405D. RGX505, RGX505D
Table 10-2
-49-