8)
Insert the wires into the connectors.
The connector positions and wire colors are shown in
Table 10-3.
NOTES:
1. RGX505 - 1 lOV, 12OV, RGX505D:
Connectors are used for terminals (7) through (101
only. The others are pin terminals
2. Terminals 111 through (61 are for a 2 mm’ wire and
terminals (71 through (10) for a 0, 75mm2 wire. Fig. lo-25
MODEL
RGX305,405 ’
220,230,24OV ! - - 1 ’ RED
WHITE BROWN ORANGE WHITE RED BROWN GREEN
RGX505
220,230,24OV WHITE ] RED WHITE RED ’ BROWN ORANGE WHITE , RED BROWN GREEN
I I
RGX305D. 405D. I I
RGX305.405 YELLOW BRACK
I I
WHITE RED BROWN ORANGE WHITE ! RED 1 BROWN GREEN
110,120v I I
Table 10-5
10-3-5 BRUSH HOLDER
1) Install the brush holders in the rear cover.
Pass the mounting screws through the brush holders,
push the brush holders so that the brushes will be per-
pendicular to the slip rings, and tighten the screws.
(See Fig. 10-26.)
54~~18mmscrew...2pcs.
NOTE: mere
are
two kinds of bursh holders.
Fig. lo-26
RGX305 RGX405, RGX405D
RGX305D RGX505, RGX505D
Fig. lo-27
-54-