Subaru Robin Power Products RGX405, RGX405D manual Tighten the cover bolt, RGX305

4)Install the rear cover to fit the rotor bearing.

Lightly strike the circumference of the rear cover evenly with a plastic hammer. (See Fig. 1O-23.)

NOTE: Be careful not to pinch the wires between the stator and rear cover.

Fig. lo-23

5)Tighten the cover bolt.

NOTE: The bolt cannot be tightetied unless the front cover and rearcover are positioned correcdy. The shape of the cover bolt is shown below.

MODEL		d			I			S
RGX305			6mm	I	130 mm			25 mm
RGX305D	i	0.24	inch	j	5.12	inch		0.98	inch
RGX405	1	8mm			135 mm			25 mm
RGX405D	-	0.31	inch		5.31	inch	:	0.98	inch
RGX505			8mm	I	155mm		(	35 mm
RGX505D	I	0.31	inch	i,	6.10	inch	i	1.38	inch

Table 10-4

6)Install the stator cover. +RGX305, RGX305D

Fit the stator cover between the stator and cover bolts until it covers all the cover bolts, and fold back the edge.

*RGX405, RGX405D and RGX505, RGX505D

Fit the stator cover all the entire cover bolts, and fold back the edge.

7)Pass the wires out of the top of rear cover through the grommet, and fit the grommet into the hole in

the rear cover. (See Fig. 10-24.) Fig. lo-24

-53-