Sun Microsystems Ethernet MMF/UTP Adapter Reset the system to activate these parameter changes

4.Set the diag-switch?parameter to true in order to see the diagnostic power-on self-test (POST) messages.

ok setenv diag-switch? true

5.Reset the system to activate these parameter changes.

ok reset-all

6.Use the show-netscommand to display the list of network devices on the system.

Among the list of devices, you should see the interfaces specific to the Sun PCI- Express Dual Gigabit Ethernet Low-Profile adapter you want to test, as shown in the following example.

ok show-nets

a)/pci@7c0/pci@0/pci@8/network@0,1

b)/pci@7c0/pci@0/pci@8/network@0

c)/pci@7c0/pci@0/pci@2/network@0,1

d)/pci@7c0/pci@0/pci@2/network@0

e)/pci@780/pci@0/pci@8/network@0,1

f)/pci@780/pci@0/pci@8/network@0

g)/pci@780/pci@0/pci@1/network@0,1

h)/pci@780/pci@0/pci@1/network@0

q)NO SELECTION

Enter Selection, q to quit:

Note – The preceding device paths are examples. The actual device paths on your system might be different from the examples shown here.

Appendix B Diagnostic Software 73