TABLE C-1lists the tunable e1000 driver parameters for Linux operating systems, and describes their function.

TABLE C-1Tunable e1000 Driver Parameters for Linux Operating Systems

Keyword

Description

 

 

FlowControl

Valid Range: 0-3 (0=none, 1=Rx only, 2=Tx only, 3=Rx&Tx)

 

Default: Read from the EEPROM

 

If EEPROM is not detected, default is 3.

 

This parameter controls the automatic generation (Tx) and response

 

(Rx) to Ethernet PAUSE frames.

RxDescriptiors

Valid Range: 80-4096

 

Default Value: 256

 

This value is the number of receive descriptors allocated by the driver.

 

Increasing this value allows the driver to buffer more incoming packets.

 

Each descriptor is 16 bytes. A receive buffer is also allocated for each

 

descriptor and can be either 2048, 4056, 8192, or 16384 bytes, depending

 

on the MTU setting. When the MTU size is 1500 or less, the receive

 

buffer size is 2048 bytes. When the MTU is greater than 1500 the receive

 

buffer size will be either 4056, 8192, or 16384 bytes. The maximum MTU

 

size is 16114.

RxIntDelay

Valid Range: 0-65535 (0=off)

 

Default Value: 128

 

This value delays the generation of receive interrupts in units of 0.8192

 

microseconds. Receive interrupt reduction can improve CPU efficiency

 

if properly tuned for specific network traffic. Increasing this value adds

 

extra latency to frame reception and can end up decreasing the

 

throughput of TCP traffic. If the system is reporting dropped receives,

 

this value may be set too high, causing the driver to run out of available

 

receive descriptors.

TxDescriptors

Valid Range: 80-4096

 

Default Value: 256

 

This value is the number of transmit descriptors allocated by the driver.

 

Increasing this value allows the driver to queue more transmits. Each

 

descriptor is 16 bytes.

XsumRX

Valid Range: 0-1

 

Default Value: 1

 

A value of 1 indicates that the driver should enable IP checksum offload

 

for received packets (both UDP and TCP) to the adapter hardware.

 

 

84 Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006

Page 118
Image 118
Sun Microsystems Ethernet MMF/UTP Adapter manual Valid Range 0-3 0=none, 1=Rx only, 2=Tx only, 3=Rx&Tx