Sun Microsystems SG-XPCIE2FC-EM8-Z c. Remove the mounting bracket screws from the top of the HBA

b.Observing ESD precautions, store the transceiver in an ESD-safe place.

c.Remove the mounting bracket screws from the top of the HBA.

FIGURE 2-3Removing the Bracket Mounting Screws

d. Remove the bracket and store it for future use.

e. Align the new mounting bracket tabs with the holes in the HBA.

Caution – Be careful not to push the bracket past the transceiver housing's grounding tabs.

Make sure the LEDs are properly aligned with the holes in the bracket.

f.Re-install the screws that attach the HBA to the bracket.

g.Re-install the transceiver by sliding it into the housing. When the latch engages, it clicks.

h.Push the bail back into place.

7.Insert the HBA into the empty PCI-Express 8-lane slot and press firmly until the adapter is seated.

8.Secure the mounting bracket of the HBA to the case with the panel screw or clip.

12 Sun StorageTek 8 Gb FC PCI-Express HBA, Emulex Installation Guide • December 2008