Sun Microsystems SG-XPCIE2FC-EM8-Z manual Testing the Installation, 2 LED Status Continued

TABLE 2-2LED Status (Continued)

Green LED	Yellow LED	State
Slow Blink	Off	Normal – Link Down or not started
Slow Blink	On	Not Defined
Slow Blink	Slow Blink	Off-line for Download
Slow Blink	Fast Blink	Restricted Off-line Mode (Waiting for Restart)
Slow Blink	Flashing	Restricted Off-line Mode, Test Active
Fast blink	Off	Debug Monitor in Restricted Mode
Fast blink	On	Not Defined

Testing the Installation

This section contains the following topics:

■“To Verify Proper Installation (for the Solaris OS)” on page 17

■“To Verify Attached Storage (for the Solaris OS)” on page 21

▼To Verify Proper Installation (for the Solaris OS)

1.Use the show-devscommand at the ok prompt to list the installed devices.

The HBA can be identified in the output by looking for the SUNW,emlxs@n and SUNW,emlxs@n,1 node names, where n is usually a single-digit number from 0 to 9. In this example, there are two dual port (SG-XPCIE2FC-EM8-Z) and one single port (SG-XPCIE1FC-EM8-Z) HBAs installed.

{0} ok show-devs

/pci@7c0/pci@0

/pci@7c0/pci@0/pci@9

/pci@7c0/pci@0/pci@8

/pci@7c0/pci@0/pci@2

/pci@7c0/pci@0/pci@2

/pci@7c0/pci@0/pci@1

/pci@7c0/pci@0/pci@9/SUNW,emlxs@0,1

/pci@7c0/pci@0/pci@9/SUNW,emlxs@0

/pci@7c0/pci@0/pci@9/SUNW,emlxs@0,1/fp@0,0

16 Sun StorageTek 8 Gb FC PCI-Express HBA, Emulex Installation Guide • December 2008