Chapter 2 Sun Fire T1000 Server Diagnostics 21
Note – For the ALOM ASR commands, see TABLE2-7.
To Run the showfaults Command

The showfaults command displays faults handled by ALOM. Use the

showfaults command for the following reasons:

Tosee if any faults have been passed to, or detected by ALOM.
Toobtain the fault message ID (SUNW-MSG-ID).
Toverify that the replacement of a FRU has cleared the fault and not generated

any additional faults.

showenvironment Displays the environmentalstatus of the host server.This information
includessystem temperatures, power supply, front panel LED, hard drive,
fan, voltage, and current sensor status. See “ToRun the
showenvironment Command” on page 22.
showfaults [-v] Displays currentsystem faults. See “ToRun the showfaults Command”
on page 21.
showfru [-g lines][-s |-d]
[FRU]
Displays information about the FRUs in the server.
• The -g lines option specifies the number of lines to display before
pausing the output to the screen.
• The -s option displays static information about system FRUs (defaults
to all FRUs, unless one is specified)
• The -d displays dynamic information about system FRUs (defaults to all
FRUs,unless one is specified). See “To Run the showfru Command” on
page24
showkeyswitch Displays the status of the virtual keyswitch.
showlocator Displays the currentstate of the Locator LED as either on or off.
showlogs [-b lines |-e lines][-
glines][-v]
Displays the history of all events logged in the ALOM event buffer.
showplatform [-v] Displaysinformation about the host system’s hardware configuration, and
whether the hardwareis providing service.
TABLE2-4 Service-Related ALOM Commands (Continued)
ALOMCommand Description