Chapter 2 Sun Fire T1000 Server Diagnostics 41
The ASR commands (TABLE2-7) enable you to view, and manually add or remove
components from the ASR blacklist. These commands are run from the ALOM sc>
prompt.
Note – The components (asrkeys) vary from system to system, depending on how
many cores and memory are present.Use the showcomponent command to see the
asrkeys on a specific system.
Note – Areset or powercycle is required after disabling or enabling a
component. If component status is changed with power on there is no effect to the
system until the next reset or powercycle.The following examples show the output
of these commands.
▼To Run the showcomponent CommandThe showcomponent command displays the system components (asrkeys) and
reports their status.
1. At the sc> prompt, enter the showcomponent command.
TABLE2-7 ASR Commands
Command Description
showcomponent*
* Theshowcomponent command may not report all blacklisted DIMMs.
Displayssystem components and their current state.
enablecomponent asrkey Removes a component from the asr-dbblacklist,
whereasrkey is the component to enable.
disablecomponent asrkey Adds a component to the asr-db blacklist, where
asrkey is the component to disable.
clearasrdb Removes all entries fromthe asr-db blacklist.