2.Fill the water reservoir with tap water (10 oz.) and close the water reservoir cover.
3.Plug the iron into a power outlet. The power indicator will light.
4. Set the Fabric Select dial to Linen and allow the iron to heat for 2 minutes.
5.Turn the Steam Control and the Fabric Select dial to OFF and unplug the iron.
6.Hold the iron over a sink in a horizontal position.
WARNING: Be careful not to touch the iron’s hot surfaces.
7.Turn the Steam Control to CLEAN. Water will begin dripping from the steam vents. To make sure that all of the water is removed from the tank, slowly rock the iron side to side and front to back for 30 seconds. When rocking the iron, dip the nose of the iron slightly below the rear of the iron to make certain the water circulates completely.
13
