Sunbeam EM2300 manual Before using your Café Ristretto

Before using your Café Ristretto™

Before using your Café Ristretto™ for the first time or if you have not used it for some time, rinse the machine by running water through without coffee in the filter handle, as follows: Note: Throughout these instructions the numbers you see highlighted and in brackets refer back to the diagrams at the start of this instruction manual.

•Open the lid of the water reservoir (1) and fill with cold water (2). Alternatively you can open the lid and remove the water reservoir using the handle (3). Then fill with cold water (4).

•Replace the water reservoir firmly into the unit (5) and close lid.

•Insert the power cord into a 230-240V AC power outlet and turn the power on. Start the unit (6) by pressing the ‘Power’ button. The power light will illuminate red and remain on until the power outlet is turned off. In addition, the ‘Warm-Up’ light will illuminate amber, this is to indicate that your espresso machine is ‘On’ and ‘Heating’ to the required temperature. Note: Before turning ‘On’ your Café

Ristretto™ ensure that the steam dial on

the control panel is not in the ‘ ’ steam or ‘Pre-Heat’ setting, but is in the ‘•’ off position.

•Place one of the filters in the filter handle

(7). Then position the filter handle onto the machines brewing head.

•To ensure that the filter handle is in the correct position, turn the handle so it points to the left and place the filter handle flat against the brewing head (8), then turn the handle towards the right (9), as far as it can go.

Note: Do not over tighten.

•Place a sufficiently large container under the filter handle (10).

•As soon as the amber ‘Warm-Up’ light goes out, this indicates that the Café Ristretto™ is ready to be used.

Tip: Remember that if the ‘Warm-Up’ light is ‘On’ it means the espresso machine is ‘Heating’. If the ‘Warm-Up’ light is Off then you can start using the espresso machine.

•Press the button (11) and allow all the water in the water reservoir to run through.

•If necessary, you may need to stop the

operation by pressing the button again, empty the container, then resume the operation.

Note: Make sure the water reservoir is clean and free of any debri, as any fine particles can block the water flow.

12