Functions of your Café Latte
1. ESPRESSO FUNCTION
For best results, it is ideal to
•Insert the power cord into a
•Fill the water reservoir (1) (2), (3) (4) (5) with cold water and start the appliance (6).
•Put the filter handle and an empty filter in place (7) (8) (9), and place cups underneath the filter handle.
•When the machine is ready, the orange
‘Warm Up’ light goes off, turn the
operating dial to setting (11).
• When the cups | are full of hot water, | |
return the operating dial to the | ’off’ | |
position. |
|
|
Note: Once the appliance has been on for a while, the coffee cups can be warmed by placing them upside down on the cup warming plate (12).
Preparing an espresso:
•Insert the power cord into a
•Fill the water reservoir (1) (2), (3) (4) (5) with cold water.
•Start the unit (6). The red ‘Power’ light and orange ‘Warm Up’ light will both illuminate.
•
•Select the required filter (7) for 1 or 2 cups of coffee and place in the filter handle.
•Using the measuring spoon supplied, place one or two measures of ground coffee into the filter (13). With the other end of the measuring spoon, use the tamper to push (pack) down the coffee grinds (14).
Important: Be sure not to
•Place the filter handle on the machines brewing head. Position the handle so it points to the left, place the filter handle flat against the brewing head, then turn the handle towards the right (16) as far as it can go.
Note: Do not over tighten.
•Place 1 or 2
•When the Sunbeam Café Latte is at the correct temperature the orange ‘Warm Up’
light will go out, then turn the operating
dial to the setting (17). You will hear the machine making a pumping noise, this is normal.
•Once the cup/s are filled to the desired level, turn the operating dial to the ‘off’ position.
•Remove the filter handle and the filter by turning the filter handle to the left.
•To remove the used coffee grinds from the filter, simply turn the filter handle upside down in a bin and gently tap out the coffee (18).
14