Sunbeam EM5400B manual Before using your Café Latte

Before using your Café Latte

Before using your Sunbeam Café Latte for the first time or if you have not used it for some time, rinse the machine by running water through without coffee in the filter holder, as follows:

Note: Throughout these instructions the numbers you see highlighted and in brackets refer back to the diagrams at the start of this instruction manual.

•Open the lid of the water reservoir (1) and fill with cold water (2). Alternatively you can open the lid and remove the water reservoir using the handle (3). Then fill with cold water (4).

•Replace the water reservoir firmly into the unit (5) and close lid.

•Insert the power cord into a 230-240V AC power outlet and turn the power on. Start the unit (6). The red ‘Power’ light and ‘Warm Up’ light will both illuminate.

•Place one of the filters in the filter handle

(7). Then position the filter handle on the machines brewing head.

•To ensure that the filter handle is in the correct position, turn the handle so it points to the left and place the filter handle flat against the brewing head (8), then turn the handle towards the right (9), as far as it can go.

Note: Do not over tighten.

•Place a sufficiently large container under the brewing head (10).

•As soon as the orange ‘Warm Up’ light

goes off, turn the operating dial to the setting (11) and allow all the water in the water reservoir to run through.

•If necessary, you may need to stop the operation by turning the operating dial to the ’Off’ position, empty the container, then resume the operation.

Note: Make sure that the water reservoir is clean and free of any debri, as any fine particules can block the water flow.

13