Functions of your Café Latte (continued)
Cleaning the steam wand/arm and froth attachment
You must clean the steam wand/arm and froth attachment immediately after each use. Simply wipe the stainless steel steam wand/ arm clean with a damp cloth and place the froth attachment under warm running water to remove any excess milk. Also, briefly turn the operating dial to 
setting to clear any remaining milk out of the steam wand/arm.
Caution: Steam from the wand/arm is extremely hot and there is danger of scalding.
Note: Should your steam wand/arm become blocked, supplied with your espresso machine is a cleaning wire. The cleaning wire for the steam arm is the BLACK pin, located under the base of the water reservoir (23)
(24). With the cleaning wire insert it into the hole in the base of the steam wand/arm (25). Should the steam wand/arm remain blocked, using the measuring spoon/tamp unscrew the steam nozzle from the steam arm (26) clean the steam nozzle by once again using the cleaning wire and flush under running water.
Hot water drinks
You are able to heat water for hot drinks such as tea or instant soups using the steam nozzle.
Note: Heating liquids is done with the steam nozzle only, so ensure that the froth attachment is not in place.
•Fill the water reservoir (1) (2) (3) (4) (5) with cold water.
•Start the unit (6). The red ‘Power’ light and orange ‘Warm Up’ light will both illuminate.
•Remove the froth attachment from the steam nozzle (21) and swing the steam nozzle to the side of the machine.
•When the Sunbeam Café Latte is the right temperature the orange ‘Warm Up’ light will go out.
•Immerse the steam nozzle in the cup or container holding the liquid to be heated and turn the operating dial to the
setting (22).
•When the liquid is hot enough, turn the operating dial to 
’off’ position and remove the container or cup.
Note: It is normal for the orange ‘Warm Up’ light to turn on and off during
heating of water.
16
