Sunbeam HG5400 manual Using your Kettle BBQ continued, Plug the cord into a 230-240volt

Using your Kettle BBQ (continued)

Using your Kettle BBQ.

1.Insert the Heat Control Probe fully into the socket of the hotplate.

2.Plug the cord into a 230-240 volt

power outlet and turn the power on. An extension cord that has been checked and tested by your electricity supplier or a qualified technician may be used with your Kettle BBQ.

3.Set the control probe dial to the desired heat setting.

Remove the lid from the Kettle BBQ and allow to heat up. When the thermostat light on the control probe switches off, the desired cooking temperature has been reached and the Kettle BBQ is ready to use.

For oven style cooking, set the dial to Super Sear setting, replace the lid and pre-heat for approximately 10 minutes.

Note: The thermostat light on the control probe indicates the Kettle BBQ is heating. This light will remain ON until the set temperature has been reached and then will cycle ON and OFF throughout cooking. This will ensure that the Kettle BBQ always maintains the selected temperature. The pre-heat time will depend on the heat setting selected.

8