SECTION 1 IMPORTANT SAFETY INSTRUCTIONS
1.8 UNPACKING YOUR PRODUCT PARTS
When you get this unit, please transport the product in an upright position only, and place the product on an even surface. Remove the cardboard box without turning it upside down, or laying it on its side.
Please note: If this unit is transported, it must be left in the normal up right position for at least 8 hours before using, to allow the coolant and compressor oil to settle.
a.Remove the adhesive tape on the top of the cardboard box.
b.Open the cardboard box.
c.Remove the Styrofoam packing and
d.Lift and hold the unit from the Styrofoam packing base by using two people, so as not to tilt the unit.
e.Remove the plastic bag.
f.Wipe it clean if necessary.
g.Then install hot air exhaust duct for condenser side according to the installation instructions.
Keep upright
Figure 2
1.9 TECHNICAL SPECIFICATIONS
| Model # | ||
| Color | Stainless Steel/White Metal | |
| Rate Cooling Capacity | 9000 BTU/hr | |
| Voltage, Frequency, Phase | AC~115V/60Hz/1 PH | |
| Rated Current | 8.2A | |
| Design Pressure | Max/High 370 psi, Min/Low 150psi | |
| Refrigerant, Quantity | R22/500g (17.6oz) | |
| Plug Capacity | 125V/15A |
|
| Plug Type | ||
| Cord Length | 6.43ft/1.96M | |
| Dehumidifying Amount | 25.4oz/h / 0.75L/hour | |
| Air Circulation Volume | 5.67CMM/200CFM | |
| Net Weight (Unit only) | 24.75 kgs/54.56 lbs | |
| Dimensions | 13.8”L x 14”W x 31.42”H / 35.1cmL x 35.6cmW x 79.8cm H | |
|
|
|
|
NOTE:
The above data are obtained under the following conditions:
Cooling condition: Dry bulb/Wet bulb: 95°F/83°F (35°C/28.3°C) according to American standard
Operating Limits During Cooling
Maximum condition: | Dry bulb/Wet bulb: 104°F/80°F (40°C/26.7°C) |
Minimum condtion: | Dry bulb/Wet bulb: 64.4°F/57.2°F (18°C/14°C) |
6