Page 36
ELITE SERIES
dANGER: TURN POWER TO SPA OFF! TO dECREASE RISK OF
dEATH, dROWNING, OR ENTRAPMENT, NEvER OPERATE SPA WHEN
FILTER IS NOT PROPERLY INSTALLEd OR IF SKIMMER ASSEMbLY IS
dAMAGEd OR ALTEREd!
Refer to the î‚¿lter cleaning/replacement procedure:
BACF
TURN POWER TO HOT TUB OFF!
DRinse debris from all filter pleats using a
garden hose and high-pressure nozzle. Start
at top and work downward to face. Repeat
process until all filter pleats are clean.
Submerge assembled filter in spa and tilt each
end upward to remove trapped air bubbles
from inside each filter cavity.
Stage 1
filter
New
Stage 2
filter
E1. Install new stage 2 filter onto clean stage 1 filter.
2. Insert retainer into stage 2 filter and rotate
clockwise to assembly. DO NOT OVERTIGHTEN
RETAINER (FINGER TIGHT ONLY)!
G1. Install filter assembly, then tighten filter nut so it
just touches filter face. DO NOT OVERTIGHTEN!
2. Turn power to hot tub back on.
Filter
Nut
1.2.
Trapped
Air
Bubbles
Top Reusable
Stage 1
Filter
1. Rotate stage 2 retainer counterclockwise
to release, then separate filter assembly.
2. Replace (throw-away) stage 2 filter after 3
months use or as needed. DO NOT REUSE!
Stage 1
filter
(Reuseable)
Stage 2
filter
Loosen filter nut to provide clearance, then
remove filter assembly.
Filter
Nut
1. 2.
Replace!
DO NOT
reuse!
Note: The Stage 2 filter cartridge cannot be
cleaned and must be (thrown out) replaced
every 3 months, or as needed.
Note: Remove and clean the Stage 1
filter cartridge once a month.