Page 2
ELITE SERIES
3.0 Important Safety Instructions for all Spa OwnersREAd ANd FOLLOW ALL INSTRUCTIONS CAREFULLY!
This spa was manufactured to meet the standards and specications
outlined in the “Virginia Graeme Baker Pool and Spa Safety Act” (VGB
Safety Act). When installing and using this spa, basic safety precautions
should always be followed, including:
1. ! dANGER: RISK OF SEvERE INjURY OR dROWNING!
Extreme caution must be exercised to prevent unauthorized access by •
children.
To avoid accidents, ensure that children do not use this spa unless •
supervised at all times. Adult supervision is a critical safety factor in
preventing children from drowning.
Use the straps and clip tie downs to secure the spa cover when not in •
use. This will help discourage unsupervised children from entering the
spa. Keep the spa cover secure in high-wind conditions.
There is no representation that the cover, clip tie-downs, or actual locks •
will prevent access to the spa.
2. ! dANGER: RISK OF SEvERE INjURY OR dROWNING!
Keep hair, loose articles of clothing or hanging jewelry away from suction •
ttings, rotating jets or other moving components to avoid entrapment
that could lead to drowning or severe injury.
Never use the spa unless all suction guards, lter, lter lid, or skimmer •
assembly are installed to prevent body and/or hair entrapment.
Never operate or use the spa if the lter, lter lid, or skimmer assembly •
are broken or any part of the skimmer assembly is missing. Please
contact your dealer or nearest service center for service.
The suction ttings and suction covers in this spa are sized to match the •
specic water ow created by the pump(s). If it is necessary to replace
the suction ttings, suction covers or pump(s), be sure that the ow rates
are compatible and are in compliance with the VGB Safety Act.
Never replace a suction tting or suction cover with one rated less than •
the ow rate marked on the original suction tting. Using improper suction
ttings or suction covers can create a body or hair suction entrapment
hazard that may lead to drowning or severe injury.
3. ! dANGER: RISK OF SEvERE INjURY FROM ELECTRIC
SHOCK OR dEATH FROM ELECTROCUTION!
Install the spa at least 5 feet (1.5m), from all metal surfaces. As an •
alternative, a spa may be installed within 5 feet of metal surfaces if each
metal surface is permanently connected (bonded) by a minimum No. 8
AWG (8.4 mm²) solid copper conductor attached to the wire connector on
the grounding lug, inside the equipment compartment on the equipment
box.