Page 38
ELITE SERIES
draining Procedures:
1. Turn off power to spa at breaker.
2. Locate the 3" gray drain valve cap on side of the
spa cabinet. Unscrew drain valve cap to expose the
underlying male garden hose tting (Fig. G-I).
3. Attach female garden hose end to drain tting and
route opposite end of garden hose away from spa
(Fig. H).
4. Pull outward on garden hose end at drain
connection (approx. 3/8") to open drain valve and
release water from spa (Fig. I). Water drains at
approximately 3 gallons per minute.
5. After spa has drained, close drain valve by pushing
inward on garden hose end at drain connection until
you feel it bottom out. Remove garden hose and
install gray drain cap before relling spa.
Note: The gray drain cap cannot be installed until the
drain valve is closed. Refer to “Spa Fill Up Procedure”
(page 15) for recommended lling instructions.
11.3 Pillow Care
Remove and clean the headrest pillows as needed
with soapy water using a cloth or soft-bristle brush.
Always remove the pillows when adding chemical shock
treatment to the spa water. The pillows can be returned to
the spa when the sanitizer reading drops below 4.0 ppm.
Pillow Removal/Cleaning Procedure
Figure G
Figure H
Figure I
3/8"
1 2
Place both hands on
pillow with thumbs as
shown.
Press inward with
thumbs to curl pillow
lip inward so you can
grab it with fingertips.
3 4
5
Flex pillow lip inward
2-3" to get a good
grip on the ends.
Gently pull outward on
pillow to release mounting
stud from receptacle on
spa shell.
Wash pillow(s) in a mild detergent soap and warm water solution. Never machine wash your pillows
or attempt to clean them with a non-approved vinyl cleaning agent!
6To reinstall pillows: Simply align pillow over mounting stud receptacle, then gently push inward to
snap in place.