Page 15
6. SET HOT TUB TO HEAT (Default Set Temp is 100˚F (38˚C)
To wa rm the hot tub water up to a comfortable temperature, follow these steps:
•The LED display on the control panel displays the actual temperature of
the hot tub water. Press either the COOLER(Down) or WARMER (Up)
button to display the “set” temperature for 5 seconds. If you want the
water to heat to a different temperature, simply press COOLER or
WARMER within 5 seconds while the “set” temperature is displayed.
The set temperature advances or decreases by one degree each time
one of these sensor pads is pressed.
•The heater will turn off when the temperature corresponding to the ther-
mostat setting is achieved.
NOTE:
•
The maximum temperature for which the hot tub can be set is 104˚F (40˚C) and
the minimum is 65˚F (18˚C).
•Setting the thermostat at maximum will not accelerate the heating process.
This will only result in a higher ultimate temperature.
•If hot tub is hooked up to a15 amp/120V (Bali) Turn off high speed pump to
operate heater.
7. PLACE COVER ON HOT TUB
• Keeping the insulating cover in place anytime the hot tub is not in use
will reduce the time required for heating, thereby minimizing operating
costs.
• The time required for initial heat-up will vary depending on the starting
water temperature and the capacity of your hot tub. Smaller hot tubs
heat at a rate of approximately 6 to 8 degrees per hour; larger hot tubs
heat at about 4 to 6 degrees per hour. The heating rate of a Bali
connected to 120VAC will be about 2 or 3 degrees per hour.
DANGER. RISK OF INJURY. Always check water temperature carefully
before entering hot tub.