Sunfire OLE-2SF manual Local IR Interface Port, IR-EmitterOut

Local IR Interface Port

Use this connector when utilizing the Olé-2SF’s local control features, such as local source control, local IR sensors, or sense-enabled auto- mated sequences.

Warning: The connection labeled “+12 Volts Out” is a voltage output. Do not con- nect a power supply to this connection!

Controlling a single local device

Controlling multiple local devices

IR-Emitter Out

The Local IR-EMITTER OUT is typically used to control a device that is not part of the main IR system, such as a TV or DVD player located within the same room as the touchpad or electronic volume controls. IR is routed to an emitter or IR distribution block connected to the Local IR output in two ways:

1.Any IR signal that is received from the Local IR-RECEIVER IN is sent out both the Local IR-EMITTER OUT and the system IR output.

2.IR signals may be specified in programming as “Local” and be routed through the Local IR-EMIT-

TER OUT.

Connect IR-EMITTER OUT and -GROUND as shown here.

13