Sunfire OLE-2SF manual

IR

Symptom	Cause	Solution
No control	1. Programming:	Verify and correct program-
of IR	missing or incorrect	ming. Test IR commands from
sources.	IR commands.	SunTools.
	2. Wiring: Incorrect	Verify and correct wiring.
	wiring between Zone
	and ‘Head-End”.
	3. Wiring: IR emitter	Verify port connection and
	connected to wrong	correct.
	source IR port of
	multi-room controller.
	IR emitter defective.	Replace IR emitter.
Intermit-	IR flooding.	Check to see if any ambi-
tent source		ent light is shining on built in
control.		IR receiver or in direct line
		with plasma TV noise. If the
		Olé-2SF cannot be relocated,
		disable the IR receiver in
		SunTools setup software and
		use a plasma friendly external
		receiver as shown on page 14
		of this manual. If installed in
		conjunction with an 3rd-party
		multi-room controller, please
		refer to its own troubleshooting
		steps.

22